#120mm fan with molex connector Pc#

Products and models may vary depending on your region.Ĭontact your local retailer for more information. Specifications are subject to change without notice.

Anti-vibration pads absorb and dampen vibrations caused by fan rotation.

Curved fan blades provide increased air pressure for maximum cooling performance.

I'm not sure if it's the case with the linked 4-pin splitter, but most. I'm using similar splitters (three-way instead of two-way) on a few of my systems at home.

Fixed RGB LED Lighting – Creates a static lighting effect, adding a stylish flair to your rig There are 4-pin fan splitters like this one and 3-pin splitters like this one, that will let you power multiple fans off of one motherboard header.

Multi-Ring RGB LED Lighting – Featuring multiple RGB LED rings circling the sides and front of the fan, the Saturn achieves a planetary ring effect to deliver a stylish yet otherworldly lighting experience.

Tail is 12 inched wrap sleeved with two wires. 4 pin connector is a pass-through so additional fans can be piggy-backed together. Great when paired with our 120V to 5Volt adapter for your Cabinet Cooling.

This 120mm Fan is ultra quiet due to it size and low voltage.

#120mm fan with molex connector Pc#

Comes equipped with curved fan blades to provide increased air pressure for maximum cooling performance. 120mm Case Fan, PC Fans Blue LED, PC Case Computer Case Fan, 4-pin Molex Connector, F12 Series 3 Packs. Low Voltage 5Volt with 4pin Molex Pass-Through Connector. It is available in 4 colors: Blue, Red, White, and Spectrum Motion (Rainbow Colors). Features Fixed RGB LED Lighting to create a static lighting effect, adding a stylish flair to your rig. Deepcool RF120 120mm LED Fan with 3-pin/LP4 Power Connector The RF120, a new member of the RF series fan, provides a targeted color LED case fan at a favorable price. Your fans all should have their voltage, wattage, and amperage load on the motor sticker, just make sure the combined amperage load of all the daisy chained fans and everything else on each wiring branch is below 11a total load and you'll be just fine.120mm fan with Molex + 3-Pin connector with a stylish Multi-Ring RGB LED Lighting design to deliver an otherworldly lighting experience. The power supply itself would have continued to power the peltier until the insulation melted away and the wiring shorted out and thankfully I discovered the overload before disaster, a lesson that could have been learned the hard way! I became interested in this subject because I came close to burning up my power supply while powering a peltier on molex cabling, the 18g wiring got so hot the insulation was close to melting because I was forcing the cabling to handle a 20a load powering the peltier. The amperage load is for the 18g molex wiring branch not the independent molex connectors themselves, you do not want to overload the wiring branch itself. on the branch is below 11a, on each independent wire branch and you'll be just fine. They connect directly to the MOLEX cable from your power supply unit (PSU). You may also come across those large and wide 4-pin connectors known as MOLEX on some fans. This will typically make a case fan nearly silent, though it will be running notably.

If the fans will run suitably at 5v, one option is to simply rewire the fans molex connector to connect to the 5v line instead of the 12v one.

Most motherboards have at least one for the CPU fan, and higher-end models often have multiple. Molex has a pin providing 5v in addition to the one providing 12v (and two ground pins in the center). The max current of the molex cabling is 11a as the industry standard is all molex cabling is 18g wiring, so to be safe make sure your total amperage load of the combined fans, HDDs, readers, optical drives etc. You can find it on premium case fans and CPU coolers.